ICD9/ICD10 codes installation

Management and Administration
#1

Hi,

Deployed openemr-6.0.0 version.
Administration > coding > External loads.
During the installation of ICD9/ICD10 codes, the installation keep-on loading for more than 2Hrs and no result. Tried to install after changing the permissions of the source file(icd-9-cm-v32-master-descriptions.zip) under the “openemr/contrib/icd9/” and still remain same.

thanks in advance.

dhayananda.T

#2
#3

Hi,

Thanks for your response.

This settings needs to be turned on only for ICD10 or for ICD9 as well ?

Made changes in configuration file(php.ini) from below link. The “mysqli.allow_local_infile” is changed to On and still the installation loading for more than one and half an hour and no result.
https://www.open-emr.org/wiki/index.php/FAQ#What_are_the_correct_PHP_settings_.28can_be_found_in_the_php.ini_file.29.3F

#4

hi @Dhayananda_T, restart the webserver, to confirm correct settings use phpinfo()

#5

Hi @stephenwaite,

I have restarted both webserver(Nginx) and php7.3-fpm service, after changes made in php.ini configuration file.

Hereby attached phpinfo( ) of my server.

Is Nginx webserver can make difference from apache2 server or either of server can use?

phpinfo
phpinfo948×628 47 KB

#6

hi @Dhayananda_T, do you see the "mysqli.allow_local_infile = On " setting?

#7

hi @stephenwaite, yes. I have updated settings "mysqli.allow_local_infile = On " allow and followed below link completely.

https://www.open-emr.org/wiki/index.php/FAQ#What_are_the_correct_PHP_settings_.28can_be_found_in_the_php.ini_file.29.3F

and restart the webserver after changing the settings.

#8

do you see the setting on the phpinfo page? if yes then check php error logs for something else that may be interfering

#9

systemctl restart php-fpm

#10

@stephenwaite Thanks for your valuable information.

regards,
dhayananda.T

1 Like
#11

@luisuriarte Thanks for your valuable information.

regards,
dhayananda.

1 Like